| Shim and Support Washers Overview
» Seeger support washers
» Seeger shim washers
Material:
Shim washers: steel St 2 K 60 (strength 600-750 N/mm²)
Support washers: spring steel HRC 44-49.
Finish:
From 2 mm thickness upwards, side faces are ground. Single thickness deviations are within the thickness tolerance.
Surface:
To manufacturer's choice
Shim washers:
Support washers:
- Self-finish and oiled
- phosphated and oiled
Please note:
The thickness values specified in the data charts apply to the self-finish and phosphated washer versions. If special versions of washers with different surface coatings are supplied, these dimensions will be increased by the corresponding coating thickness.
Important:
The thickness tolerances of washers with thickness of 1.2/1.5/2.0 mm deviate from DIN 988. The 15 x 22 washers and the washers from 100 x 125 onwards are not covered by DIN 988. The same applies to shim washers with thickness of 0,15 and 0,25 mm.
Diameter tolerances:
Nominal diameter
range |
Outer Diameter D
(ISO-Tolerance d12) |
Inner Diameter d
(ISO-Tolerance d12) |
| 3 to 6 mm |
-0,030
-0,150 |
+0,150
-0,030 |
| over 6 to 10 mm |
-0,040
-0,190 |
+0,190
+0,040 |
| over 10 to 18 mm |
-0,050
-0,230 |
+0,230
+0,050 |
| over 18 to 30 mm |
-0,065
-0,275 |
+0,275
+0,065 |
| over 30 to 50 mm |
-0,080
-0,330 |
+0,330
+0,080 |
| over 50 to 80 mm |
-0,100
-0,400 |
+0,400
+0,100 |
| over 80 to 120 mm |
-0,120
-0,470 |
+0,470
+0,120 |
| over 120 to 180 mm |
-0,145
-0,545 |
+0,545
+0,145 |
| over 180 to 250 mm |
-0,170
-0,630 |
+0,630
+0,170 |
|
